POSITIP 880 69
I – 6 Programming POSITIP 880
Enter the distance from the point of intersection on
the line in the “FROM” step. Use the numeric keys to
enter the distance.
Enter the distance from the point of intersection on
the line in the “TO” step.
Enter the angle measured from the line along the X
axis and sweeps toward the adjacent line. Use the
numeric keys to enter the angle.
Pressing the CLOSE CONTOUR soft key causes the
chamfer to connect the first block in the current path
instead of the next block. The block number shown in
the “TO” field will change.
When the desired data has been entered, press USE.
LENGTH 1
LENGTH 2
ANGLE
CLOSE CONTOUR
To Next Page
Loading...
