HEIDENHAIN TNC 320 - Page 15

HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 15
1.2 Compatibility
214, Circular pocket finishing – þþ þþ
215, Circular stud finishing – þþ þþ
220, Polar pattern Q301
Q365
þ
þ
þ
–
–
–
–
–
221, Cartesian pattern Q301 þþ ––
225, Engraving – þ –––
230, Multipass milling – þþ þþ
231, Ruled surface – þþ þþ
232, Face milling – þ xxx
240, Centering – þ xxx
241, Single-lip deep-hole drilling – þ xxx
247, Datum setting – þþ xx
251, Rectangular pocket (complete) – þ xxx
252, Circular pocket (complete) – þ xxx
253, Slot milling (complete) – þ xxx
254, Circular slot (complete) – þ xxx
256, Rectangular stud (complete) – þ xxx
257, Circular stud (complete) – þ xxx
262, Thread milling - þþ xx
263, Thread milling/counter sinking – þþ xx
264, Thread drilling/milling – þþ xx
265, Helical thread drilling/milling – þþ xx
267, Outside thread milling – þþ xx
270, Contour train data – þ xxx
275, Trochoidal slot – þ xxx
276, 3-D contour train – þ xxx
290, Interpolation turning – þ xxx
Cycle
Additional
parameters
iTNC 530
TNC 426/
TNC 430
TNC 310 TNC 410
340490 280476 286140 286060