16
1.2 Compatibility
Fixed cycles of NCK-based TNC 320, TNC 620 and TNC 640
controls
Meaning of the symbols used in the table:
– Parameter not available in this software version
þ Parameter or cycle available in this software version
x Cycle not available in this software version
Cycle Additional parameters TNC 320 TNC 620 TNC 640
340551 340560 340590
1, Pecking – þþþ
2, Tapping – þþþ
3, Slot milling – þþþ
4, Pocket milling – þþþ
5, Circular pocket – þþþ
6, Rough out (SL I) – x x x
7, Datum shift – þþþ
8, Mirror image – þþþ
9, Dwell time – þþþ
10, Rotation – þþþ
11, Scaling – þþþ
12, Program call – þþþ
13, Spindle orientation – þþþ
14, Contour definition – þþþ
15, Pilot drilling (SL I) – x x x
16, Contour milling (SL I) – x x x
18, Thread cutting – þþþ
19, Working plane – þþþ
20, Contour data – þþþ
21, Pilot drilling – þþþ
22, Rough-out Q208
Q401
þ
–
þ
–
þ
–
23, Floor finishing – þþþ
24, Side finishing – þþþ
25, Contour train – þþþ
To Next Page
Loading...
