9
6. Align the QR code on your mobile device with the camera lens and keep a
distance of 4-8 inches. Tap ”When you hear a beep or a green light” after you
hear two beeps from the camera.
7. Wait for the connection.
8. Name your camera and tap Start to experience to finish the connection.
Connect the camera by AP hotspot
Power on the camera, wait until you hear ”Please configure camera by AP hotspot or
scanning code”.
Notes:
• Please enable Location Services on your mobile device and allow HeimLink to
access your location.
• No password is required for the wifi HeimLink_AP_xxxx. If your mobile device
prompts you that the Wifi is unsecure, please ignore it.
To Next Page
Loading...
