Heiniger saphir - Page 18

18 Translation of the original instructions / Small animal clipper
Malfunction Cause Rectication
Motor does not work Faulty motor and / or elec-
tronics
Have motor and / or electronics
replaced (S)
Clipperhead blocked Clean and oil clipperhead
Motor runs very
slowly
Clipper blades were not
oiled su󰀩ciently
Oil clipper blades
Running time of a
fully charged battery
is too short and / or
blades are getting
hot
Clipper blades were not
oiled su󰀩ciently
Oil clipper blades
Dead, not fully charged or
defective battery has been
used
Only use intact and completely
charged original battery
The control light of
the charging station
in not on
Charging station is not con-
nected to the power supply
Connect the charging station to the
power supply
Charging station is faulty Have charging station inspected (S)
When battery is un-
loaded the light does
not change from
green to red
Contacts of battery and/or
charging station are dirty
Clean contacts
Faulty battery Replace battery
Contacts of the charging
station are deformed
Have the charging station repaired (S)
LED ashes alter-
nately red / green
Faulty battery Replace battery. Individually test bat-
teries if two batteries are inserted into
the charging station at the same time.