Combined detergent
Detergent manufacturers also produce combined detergents called “2 in 1”, “3 in 1” or “5 in 1”
etc.
“2 in 1” detergents contain detergent + salt or rinse aid. When using “2 in 1” detergents make
sure to check the specifications of the tablet consists of.
Other tablet detergents contain detergent + rinse aid + salt + varlous extra functions.
Generally, combined detergents produce sufficient results under certain usage conditions only.
Such detergents contain rinse aid and/or salt in preset amounts.
Points to consider when using this type of products:
• Always make sure to check the specifications of the product you will use or whether or
not it is a combined product.
• Check if the detergent used is appropriate for the hardness of mains water that
machine is appertaining to.
• Observe the instructions on packagings when using such products.
• If such detergents are in the form of tablets, never put them into the interior section or
the cutlery basket of the dishwasher. Always put the tablets into the detergent
compartment in the detergent dispenser.
• They produce good results for certain types of usage only. If you are using this type of
detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
• When the conditions of use of such products and the machine settings are appropriate,
they ensure savings in salt and/or rinse aid consumption.
• Contact the detergent manufacturers if you are not obtaining good wash results (if
your dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The
scope of warranty for your machine does not cover any complaints caused by the use
of these types of detergents.
Recommended usage: If you want to obtain better results while using combined detergents,
add salt and rinse aid into your machine and adjust the water hardness setting and the rinse aid
setting to the lowest position.
Solubility of the tablet detergents produced by different companies can vary depending on the
temperature and time. Therefore, it is not recommended to use such detergents in short
programs. It is more suitable to use powder detergents in such programs.
Warning: Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
• Fill the salt and rinse aid compartments.
• Adjust the water hardness setting to the highest position (6) and run an empty-wash.
• Adjust the water hardness level.
• Make the suitable rinse aid setting.
Rinse-aid usage
The rinse aid helps to dry the dishes without streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The rinse aid is automatically released during the hot rinse
phase. If rinse aid dosage setting set too low, whitish stains remains on dishes and dishes do
not dry and washed clean. If rinse aid dosage setting set too height, you can see bluish layers
on glass and dishes.
Filling with rinse aid and making the setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
To Next Page
Loading...
Need help?
General
