CHAPTER -3: INSTALLATION (WATER INLET HOSE CONNECTION)
•
Your machine may have either a single inlet
(cold) or double water inlets (cold/hot) based on its
specifications.
White-capped hose should be connected to cold water inlet
and red-capped hose to hot water inlet (applicable for
machines with double water inlets).
•
To eliminate water leakages in points of
contact, 1 or 2 nuts are provided in the hose package
(applicable for machines with double water inlets). Fit these
nuts to the ends of new water inlet hoses on the side of
faucet.
• Mount new water inlet hoses to a ¾ ˝, threaded faucet.
•
Connect the white-elbow end of the water inlet hoses to
the white-filtered water inlet valve on the rear side of the
machine and the red-elbow end to red-filtered one
(applicable for machines with double water inlets).
Tighten plastic parts of the junctions using your hand. In
uncertain conditions, have the connection works be done
by a qualified plumber.
•
Flow of water with pressure of 0,1-1 Mpa will allow your
machine to operate more efficiently.) (0,1 Mpa pressure
means that more than 8 litres of water will flow through
a fully-tapped faucet per one minute.)
To Next Page
Loading...
Need help?
General
