CHAPTER -7: MAINTENANCE AND CLEANING OF YOUR MACHINE
(WATER INLET FILTERS)
Filters to avoid dirt and foreign substances in the water from
penetrating into the machine are available both on the side of
faucet and on the ends of water valves along the water inlet
hose of your machine. If your machine cannot intake sufficient
amount of water despite water faucet being open, these filters
should be cleaned. (It is recommended that you clean your
pump filter once in 2 months).
•
Detach the water inlet hoses.
•
Remove the filters on water inlet valves using
pliers and then clean it with a brush in water.
•
Disassemble the filters on the side of faucet
side of water inlet hoses manually and clean it.
•
Having the filters cleaned, you can fit them in
the same way reversely.
CAUTION:
Filters of water inlet valves may be clogged due to contaminated water faucet or
lack of necessary maintenance or valves may be broken down, causing water
leaking into your machine continuously.
The breakdowns that may arise due to these reasons are out of the scope of
warranty.
To Next Page
Loading...
Need help?
General
