WASHING CLOTHES AT FIRST TIME
Before washing clothes at first time, the washing machine shall be operated in ne round of the
whole procedures without clothes in as follows:
1.Connect power source and water.
2.Put a little detergent into the box and close it.
3.Press the button “On/Off”.
4.Press the button “Start/Pause”.
The drawer is separated as follows:
I: Pre-detergent or washing powder.
II: Main detergent, softener, pre-dip, bleaching or decontaminating products.
: Washing additive, such as fabric softener or tackifier.
PUT DETERGENT INTO WASHING MACHINE.
1.Pull out the drawer.
2.Fill pre-detergent into Case I (when necessary).
3.Fill detergent into Case II.
option1: detergent (powder) . option2(liquid)
4.Fill softener into Case (when necessary).
Notes:
- As for the agglomerated or ropy detergent or additive, before they are poured into the detergent
box, it is suggested to use some water for dilution to prevent the inlet of detergent box from being
blocked and overflowing while filling water.
- Please choose suitable type of detergent for the various washing temperature to get the best
washing effect with less water and energy consumption.
START UP WASHING MACHINE
Connect the power. Check if water pipes are connected properly. Open the tap completely. Put in
the clothes to be washed and fill in the detergent and tackifier. Then press the button
“On/Off”,Select the proper procedures and functions and press the button “Start/Pause”.
To Next Page
Loading...
