Proper maintenance on the washing machine can extend its working life. The surface can be
cleaned with diluted non-abrasive neutral detergents when necessary. If there is any water
overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to strike the
cabinet.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
CLEAN INTERNAL DRUM
The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
Never use steel wool.
DISPOSE A FROZEN WASHING MACHINE
When the temperature drops below zero and your washing machine gets frozen, you may:
1.Disconnect the power supply for the washing machine.
2.Wash the tap with warm water to loosen inlet pipe.
3.Take down inlet pipe and immerse it in warm water.
4.Pour warm water into washing drum and wait for 10 minutes.
5.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Notes: when the washing machine is reused, make sure the ambient temperature is above 0 C
ANTI-FREEZE
If your washing machine is located in the room where it can get frozen easily, please drain
the remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1.Close the tap.
2.Screw off the inlet pipe from tap and put its end into the container.
3.Start up any procedure except single Wash or Drain procedure. Water will be drained out of inlet
pipe if any for about 40 seconds.
4.Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump
WARNING!
To avoid burning, it shall be done after the hot water inside the machine cools down.
To Next Page
Loading...
