CLEAN DETERGENT BOX AND GROOVES
Clean detergent drawer and grooves
1.Press down the arrow location on softener cover inside the drawer.
2.Lift the clip up and take out softener cover and wash all grooves
with water.
3.Restore the softener cover and push the drawer into position.
CLEAN INLET FILTER
Inlet filter shall must be cleaned if there is not any or insufficient
water in when the tap is opened.
Clean the tap filter:
1.Close the tap.
2.Select any procedure except “Wash” or “Drain” procedure.
3.Press the button “Start/Pause” and keep the procedure running for
about 40 seconds.
4.Remove the inlet pipe from the tap.
5.Use water to wash the filter.
6.Reconnect the inlet pipe.
Washing the filter in washing machine:
1.Screw off the inlet pipe from the backside of the machine.
2.Pull out the filter with long nose pliers and reinstall it back after
being washed.
3.Reconnect the inlet pipe.
4.Open the tap and make sure there is no water leakage.
5.Close the tap.
Notes: Generally, the tap filter is washed first and then the filter in
washing machine will be washed.
If only the filter in washing machine is washed, then the steps 1~3 in
cleaning the tap filter shall be repeated.
To Next Page
Loading...
