Heinner HWM-M7012HA+++ - Page 23

www.heinner.com
22
Display LED
Description
Reason
Solution
Door lock problem
Door is not closed properly
Restart after the door is closed.
Please call up service line if there are still troubles.
Water injecting
problem while
washing
Tap is not opened or water flows too
slowly.
Inlet valve filter is blocked.
Inlet pipe is twisted.
If water is not supplied
Open the tap or wait till the
water supply becomes normal.
Check inlet valve filter.
Straighten the water pipe
Check the other taps in the room.
Please call up service line if there are still troubles.
Drain problem
while washing
Outlet hose is blocked or twisted
Drain pump is blocked
Wash and straighten outlet hose.
Wash drain pump filter
Please call up service line if there are still troubles.
Please call up the service line if there is any other problem
ELECTRICAL WARNING
To avoid fire,electrical shock and other accidents,please remember the following reminding:
- Only the voltage indicated in power label can be used. If you are not clear of the voltage at home,
please contact the local power bureau.
- When you are using the heating function, the maximum current through the washing machine will
reach 10A. Therefore, please make sure the power supply units (current, voltage and cable) can meet the
normal load requirements for the machine.
- Protect the power cord properly. Power cord shall be fixed well so that it will not trip the people or
other things and be damaged. Special attention shall be paid to the socket. It shall be plugged into the
sockets easily and attention shall be paid to the plug location.
- Do not make the wall-mounted socket overloaded or cable extended. Overloading of the wiring may
cause fire or electrical shock. Do not pull out power plug with wet hand.
- To ensure your safety, power plug shall be inserted into an earthed three-pole socket.
Carefully check and ensure that your socket is properly and reliably earthed.