ADJUST LEG
1. When positioning the washing machine, please first check if the legs are closely attached to the
cabinet. If not, please turn them to their original positions with hand or spanner and tighten the nuts
with spanner.
2. After positioning the washing machine, press four corners on top cover of washing machine in
sequence. If the washing machine is not stable when being pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine. Loosen the lock nut with spanner and turn the leg
with hand until it closely contacts with the floor. Press the leg with one hand and fasten the nut closely
to the cabinet with the other hand.
4. After being locked properly, press four corners again to make sure that they has been adjusted
properly. If it is still unstable, it has to repeat Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the washing machine from in the
left, right, front and back directions. If the cylinder keeps stable, the washing machine is positioned
level. If it rolls, the washing machineis positioned unlevel. The rolling direction is the direction of lower
ground surface.Then, the two legs in this direction shall be raised at the same time until the washing
machine is level. Steps 1~3 are repeated to make the bottom legs closely against the ground and the
nuts shall be locked tightly.
CONNECT INLET PIPE
Connect the inlet pipe as indicated in the figure. For the model which has hot valve, please connect the
hot vale to hot water tap. Energy will decrease automatically for some program.
INSTALL INLET PIPE
1. Connect the elbow to tap and fasten it clockwise.
2. Connect the other end of inlet pipe to the inlet valve at the backside of washing machine and fasten
the pipe tightly clockwise.
Notes: after connection, if there is any leakage with hose, then repeat the steps to connect inlet pipe.
The most common type of tap shall be used to supply water. If tap is square or too big, then standard
tap shall be changed.
To Next Page
Loading...
