Heinzmann Programmer 2 User Manual

7 Error Handling
Programmer PG 02 41
3050 ErrFeedback 3150 SerrFeedback
Cause: Error in feedback system of actuator, actuator not connected.
Response: - Governor cannot be put into operation.
- Emergency shutdown.
Actions: - Check feedback cable to actuator.
- Check actuator, replace if necessary.
- Check error limits for feedback:
1952 FeedbackErrorLow / 1953 FeedbackErrorHigh
3051 ErrFeedback2 3151 SerrFeedback2
Cause: Error in feedback system of actuator 2, actuator 2 not connected.
Response: - Governor cannot be put into operation.
- Emergency shutdown.
Actions: - Check feedback cable to actuator.
- Check actuator, replace if necessary.
- Check error limits for feedback:
1962 FeedbackErrorLow2 / 1963 FeedbackErrorHigh2
Note: These parameters are implemented only in the PRIAMOS III series.
3052 ErrFeedback3 3152 SerrFeedback3
Cause: Error in feedback system of actuator 3, actuator 3 not connected.
Response: - Governor cannot be put into operation.
- Emergency shutdown.
Actions: - Check feedback cable to actuator.
- Check actuator, replace if necessary.
- Check error limits for feedback:
1972 FeedbackErrorLow / 1973 FeedbackErrorHigh
Note: These parameters are implemented only in the PRIAMOS III series.

Heinzmann Programmer 2 Specifications

General

Brand	Heinzmann
Model	Programmer 2
Category	Motherboard
Language	English