1
Preparation before use
Note:
If the air conditioner you purchased is a Cooling Only one, but you preset the remote controller as Heat Pump, it doesn't.
But if the air conditioner you purchased is a Heat Pump one, and you preset the remote controller as Cooling only, then
you CAN NOT preset the Heating operation with the remote controller.
Remote Controller presetting
Before using the air conditioner, be sure to check and preset the following.
Auto Restart Presetting
The remote controller is NOT preset as Cooling Only Air Conditioner or Heat Pump by manufacturer.
User can preset the remote controller type depending on the air conditioner type you have purchased
as follows:
Each time after the remote controller batteries are replaced, the Cooling indicator and
Heating indicator will flashes alternately on LCD of the remote controller.
Press any button when flashes, Heat Pump is set.
Press any button when flashes, Cooling Only is set.
If you don't press any button within 12 seconds, the remote controller is preset as Heat Pump automatically.
If you want auto restart function, when the appliance is energized, hold down the Emergency
button (ON/OFF) on the indoor unit for over 5 seconds, auto restart function is set with buzz sound,
air conditioner is on standby.
If auto restart has been set, hold down the Emergency button (ON/OFF) on the indoor unit for over 5
seconds, auto restart function is canceled with buzz sound, air conditioner is on standby.
* Back-Light Function (Optional)
Hold down any button of remote controller for about 2 seconds, back-light turns on. Release the button,
it turns off automatically 10 seconds later. Note: Back-light is an optional function.
To Next Page
Loading...
Need help?
General
