Each time MODE button is pressed, the operation mode
is changed in sequence:
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
18 ~32
Heating mode is NOT available for cooling only air conditioner.
HEATING
COOLING
DRY
FAN ONLY
Selecting mode
FAN mode
2
+
-
Auto
High Medium
Low
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, airflow is set at "Low" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press once to temperature setting by 1lower
Press once to temperature setting by 1raise
Range of available set temperature
*HEATING, COOLING
DRY
FAN
unable to set
room temperature
Turning on
SWING, SMART, TIMER, SLEEP and SUPER operation modes will be specified in the following pages.
Press button, when the appliance receives the
signal, the RUN indicator of the indoor unit lights up.
ONLY
Operation instructions
7
Operation modes
*Note: Heating mode is NOT available for cooling only models.
SLEEPSLEEP
LowLow
HighHigh
CC
hh
MODEMODE
TIMERTIMER
SUPERSUPER
SMARTSMART
FANFAN
SWINGSWING
2
1
3
4
Changing modes during operation, sometimes the unit does not response
at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
During heating operation, air flow is not discharged at the beginning.
After 2-5 minutes, the air flow will be discharged until temperature of
indoor heat exchanger rises.
To Next Page
Loading...
Need help?
General
