Do not switch on when the
water pressure isn't within
0.03MPa-0.85Mpa, so as to
protect the inlet valve.
Make sure the lid is closed
especially during spin.
Maintenance
Clean the filter in the inlet valve
Clean the filter in the inlet valve regularly in order to prevent it from clogging
1.First unplug the power cord .
2.Take off the inlet hose and clean the filter with a brush.
The appliance is not intended
for use by young children or
infirm persons unless they have
been adequately supervised
by a responsible person to
ensure that they can use the
appliance safely. Young
children should be supervised
to ensure that they do not play
with the appliance.
If the appliance is supplied from
a cord extension set or electrical
portable outlet device, the cord
extension set or electrical portable
outlet device must be positioned
so that it is not subject to
splashing or ingress of moisture.
The power cord must be
unplugged after use. Pleas use
low foam powder detergent.
The appliance is to be connected
to the water mains using new
hose-sets and that old hose-sets
should not be reused.
The highest point of the drain
hose must be within 90cm above
floor level.
İ
90cm
To Next Page
Loading...
