Malfunction phenomenon
Start the washing machine from Rinse
Process, the washing machine does
not input the water
The wash process changes from Spin
to Rinse
The control button is useless to touch
spin delay
The washing machine will start from the spin process
in order to spin out the water and detergent from the
clothes, then input the water (if there is water in the tub
it will drain out the water first)
When the clothes are not even or are on a single side
of the tub, the washing machine will input the water and
make the clothes balance and even.
If want to change the PROCESS after the washing
machine started, please touch the Start/Pause button
to reset the process
Trouble Shooting
Reason
Before maintenance
Problem
Checklist
Does not work
Is electricity present?
Is the tap opened?
Is the plug loose, or fuse broken?
Turn on the power or start button?
Fail to fill water
Is the tap opened?
Is the drain hose frozen?
Is the water supply cut?
Is the water inlet valve blocked?
Body Maintenance
Clean the lint filter
Note:
Clean the surface of the washing machine with a soft
cloth regularly.
After washing starched or bleached laundry, the inner
tub must be clear ,or deposit will appear.
The washing machine will delay 15 to 60 seconds to enter
spin process after drain or after select spin process only
1. Pully upward to remove
the filter assy's.
2. Take the filter from
the filter cover.
3. Clean and rinse
it thoroughly.
4. Reinstall the filter.
To Next Page
Loading...
