Outlet:
Installation and connection of the inlet hose
Connection of the inlet hose
1.Select the appropriate type
1.Unscrewing the part “a” from the water faucet.(As figure 1)
2.Respectively attach the water inlet hose to the water faucet.(As figure 2)
3.Run water through both faucet and inlet hose,into a bucket or laundry tub,to get
rid of particles in the water line that might clog the inlet valve screen.
4.Attach the hose connected with the water faucet to the water inlet valve.(As figure 3)
5.Check for leak
1)Swing the water inlet hose gently to confirm if it’s suitable.
2)Turn on the water faucet and check for leak.A small amount of water might enter the washer.
You will drain this later.
Do not overtighten.Damage to the valve can result.
Note:
Do not overtighten.Damage to the valve can result.
Note:
of outlet as shown in the figure.
2.End of outlet spout should be more than
10mm, or the connector cannot be assembled.
3.Water leakage is
possible from here.
To Next Page
Loading...
