HELLER HTLW7 - Wash Completion

8.Wash over
1
The Buzzer will alarm after the program finish, and it will power off
Unplug the power cord.
2
Program Time Table
wash 16 spin 3 wash 3 spin 3
w
ash 3 spin 4 44
wash 18 spin 3 wash 3
spin 3
w
ash 3 spin 3
w
ash 3 spin 5 57
wash 3 spin 2 wash 2
w
ash 2 spin 3 26
wash 3 spin 2 wash 2 spin 2 13
spin11 wash 16 spin 10 89
spin 38 40
TOL
Program
Fuzzy
Heavy
Gentle
Speedy
Normal
Air dry
Wash
Rinse
1st Rinse 2nd Rinse 3rd Rinse
Spin
(min)
Inlet water
Inlet water
Inlet water
Inlet water
drain water
drain water
drain water
drain water
Spin 2
soak 20
wash 24
Computer sequencer saves up 6 kinds of washing programs, all kinds of programs are shown as washing
process form.
In soaking process, washing is that take clothes moving soak for some time, then begin to work as gently
wash program, so as to pre-wash fully and improve the clean ratio.

Fuzzy means the machine can set the water level automatically according to the loading, if
other water level is needed,you can press Water level button. But if there is some water in the
tub before pressing Start/Pause, this function will lose effectiveness, and water level is 5.
Under the fuzzy function, the water level maybe improper if you put the clothes into the tub
after pressing START/STOP button.
If pressing START/STOP button is later than pressing Process, Program or Water level button,
it will cancel the fuzzy function automatically.
Memory means if the operation is interrupted for cutting off electricity,and pressing the
START/PAUSE button in 10 minutes after the power returns to normality, the machine can
continue the unfinished operation. Beyond 10 minutes and do not press START/PAUSE button,
the machine will turn off automatically.
Fuzzy function and memory function
All manuals and user guides at all-guides.com