Contents Page
1.WARNINGS 3
1.1. Check before taking a sauna bath 3
1.2. Sauna room 3
1.3. Information for users 3
1.4. Operation of the sauna heater controls 3
2.Heating the sauna 4
2.1. Recommended sauna room ventilation 4
2.2. Installing the sensor near a supply air vent 4
2.3. Ceiling installation of the sensor 5
2.4. Installing the Extra NTC sensor 5
2.5. Sauna heater stones 5
2.6. If the sauna heater will not heat up 6
2.7. Preparing for sauna heater installation 6
2.8. Installation 6
2.9. Heater safety distances and sensor position 7
2.10. Connection of the sauna heater to the mains 8
2.11. Electric heating toggle 8
2.12. Locating the connecting box for the connection cable in the sauna room 9
2.13. Remote controlling 9
2.14. Order of RJ 10 connectors 9
2.15. Door switch 10
2.16. Wiring diagram Cup Heater and Contactor box WE 30 and WE 40 11
2.17. Principle image when Pure is used as control panel 12
3. Spare parts for Cup D -electric sauna heater 13
4. ROHS 13
Figures and tables
Figure 1. Rekommended sauna room ventilation 4
Figure 2. Heater installation to wall 7
Figure 3. Heater safety distances and sensor position to wall 40 mm from ceiling 7
Figure 4. Alternative installation location 7
Figure 5. Location for the connection box 9
Figure 6. PCB OLEA 103 9
Figure 7. Installing the door switch 10
Figure 8. Pin - order of RJ 10 10
Figure 9. Wiring diagram for the sauna heater 11
Figure 10. Wiring diagram Contactor box WE 30 and WE 40 11
Figure 11. Principle image 12
Table 1. Safety clearances 8
Table 2. Connection cable and fuses 8
Table 3. RJ 10 connectors to circuit board 9
Table 4. Connecting the door switch. 10
Table 5. Spare parts for Cup D 13
To Next Page
Loading...
