ADLY MOTO
1-1
1. INFORMATION FOR PREPARATION
*** Attention of Operation ***
All the washers, oil rings, clamping rings, cotter pins, etc., shall be replaced by new one when
they have been disassembled.
After slightly locking the screws, bolts and nuts, etc., first, tighten them according to the
tightening tension stipulated with the opposite angle's way from big diameter's screw to small
diameter's screw, and from inside to outside.
Must use the pure and original oil, grease, and parts.
Must use the professional tools and the general tools to repair.
Must clean the parts checked after disassembling the parts, and put the grease to lubricate the
operation face when assemble the parts.
To Next Page
Loading...