ADLY MOTO 12-1
ELECTRICAL DEVICE
Attention of Operation
‧Remove battery from truck for charging.
‧No charging with fast speed if it’s not urgent necessary.
‧Must check voltage with Watt-hour meter.
‧Must replace the battery with tranditional battery.
‧Due to it’s CDI ignition device, so, no adjusting ignition time. Check CDI set
& ACG if ignition time is poor. And replacing it if it’s poor, confirm ignition
time with original service meter.
‧Disassembly start motor without disassembling the engine.
Diagnosis of Trouble
No power
‧Battery discharging.
‧Fallening connection wire of battery.
‧Fuse broke.
‧Poor main switch.
Low voltage
‧Poor charging of battery.
‧Poor contact.
‧Poor charging system.
‧Bad rectifier.
Current off and on
‧Poor contact of battery wires.
‧Poor contact of discharging system.
‧Poor contact or short circuit of
ignition system.
Light weak
‧Battery discharging.
‧Resistance of wiring, switch too big.
Poor changing system
‧Fuse broke.
‧Poor contact, broke and short circuit
of connection head or socket head.
‧Poor rectifier.
‧Poor ACG.
Spark plug no works
‧Poor contact spark plug.
‧Poor contact, broke and short circuit
of main wire.
–Between ACG & C.D.I.
‧Between CDI & ignition coil.
–Between CDI & main switch.
‧Bad ignition coil.
‧Poor CDI set.
‧Poor ACG.
High/low beams can’t be changed
‧Bad bulb.
‧Poor lighting switch.
To Next Page
Loading...