Page 3Item 56932
Power Tool Use and Care
1.
The correct power tool will do the job better and
safer at the rate for which it was designed.
2.
Any power tool that cannot be controlled with the
switch/trigger is dangerous and must be repaired.
3.
Such preventive safety measures reduce the
risk of starting the power tool accidentally.
4.
Power tools are
dangerous in the hands of untrained users.
5.
Many accidents
are caused by poorly maintained power tools.
6.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
7.
Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Service
1.
This will ensure that
the safety of the power tool is maintained.
2.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Safety Warnings Common for
Grinding, Sanding, Wire Brushing,
or Polishing Operations
1.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
2.
Operations for which the
power tool was not designed may create
a hazard and cause personal injury.
3.
Just because the
accessory can be attached to your power tool,
it does not assure safe operation.
4.
Accessories running faster than
their RATED SPEED can break and fly apart.
5.
Incorrectly sized accessories
cannot be adequately guarded or controlled.
6.
Accessories
with arbor holes that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
7.
Damaged accessories
will normally break apart during this test time.
8.
The eye protection must
be capable of stopping flying debris generated by
various operations. The dust mask or respirator
must be capable of filtering out particles generated
by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
9.
Fragments of workpiece or of a
broken accessory may fly away and cause
injury beyond immediate area of operation.
To Next Page
Loading...
