Page 6 For technical questions, please call 1-888-866-5797. Item 57675
TABLE A: RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS* (120/240 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25´ 50´ 75´ 100´ 150´
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
* Based on limiting the line voltage drop to five volts at
150% of the rated amperes.
Warning Symbols and Definitions
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to
avoid possible injury or death.
Indicates a hazardous
situation which, if not
avoided, will result in death or serious injury.
Indicates a hazardous
situation which, if not
avoided, could result in death or serious injury.
Indicates a hazardous
situation which, if not
avoided, could result in minor or moderate injury.
Addresses practices not
related to personal injury.
Symbology
V
Volts
A
Amperes
n
0
xxxx/min.
No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before set-up and/or use.
Keep hands clear of fence area.
DANGER marking concerning
Risk of Amputation.
Keep hands well clear of cutting area.
Bright Light.
To prevent eye injury,
do not stare into light.
SPECIFICATIONS
Electrical Rating 9$&+]$
Spindle No Load Speed 4,100 RPM
Max. Accessory Diameter
%ODGH'LDPHWHU±
Arbor 5RXQG
Maximum Blade Kerf Ǝ
Capacity of Cut
50° Miter Left and Right
48° Bevel Left and Right
Cutting Capacities
ANGLE
MAXIMUM
CAPACITY OF CUT
RESULT
0° Miter
Height Width
Width Height
45° Miter
Height Width
Width Height
45° Bevel
Left
Height Width
Width Height
45° Bevel
Right
Height Width
Width Height
To Next Page
Loading...
