12/16 – User Manual
6.8. Using the pitch faders
- Click and move pitch faders in the top right and left sections of the Hercules Mobile DJ Mix
window or on the controller itself to adjust the corresponding track’s bpm and pitch (displayed
above and below the faders, respectively). Moving a fader upwards makes the track on the
corresponding deck slower, while moving a fader downwards makes the track on that deck faster.
Note: Synchronizing the bpm between tracks is very useful to help dancers keep dancing to the
same beat! The heart symbols on the Mobile DJ MP3’s screens represents a track’s BPM.
- Click the R button beside a fader to reset the pitch to 0%.
6.9. Loading the next track in the list
- Click the Next button beside a fader to load the next track in the list.
6.10. Setting cue points
You can set up to three cue points for a track. To do so:
- Click the 1, 2, or 3 buttons in the central section of the Hercules Mobile DJ Mix window for cue
points 1, 2 or 3, respectively.
- Click the Set a CUE point button beside the 1, 2 and 3 buttons to mark the cue point you have
selected.
- Click the 1, 2, or 3 buttons in the central section of the Hercules Mobile DJ Mix window to select
cue points 1, 2 or 3 and then either press the CUE button on your Mobile DJ MP3 controller or
click the CUE button in the software to jump to the corresponding cue point.
6.11. Adjusting gain/EQ/cut-off filter effect
- Click the gain, EQ (high, mid, low) or cut-off filter knobs in the central section of the Hercules
Mobile DJ Mix window and move your mouse to increase or decrease the value of each.
To Next Page
Loading...
