MY21H01 - 32_1.0_30.07.2020
42
Operation
Figure 27: Pulling the locking lever upwards; All Up used
as an example
2 Pull out the handlebars to the required height.
Observe minimum insertion depth.
3 Close the stem clamping lever.
6.5.3.2 Adjusting the quick release
clamping force
If the handlebar clamping lever stops before
reaching its end position, unscrew the knurled
nut.
Tighten the knurled nut on the seat post if the
seat post clamping lever's clamping force is not
effective enough.
If you are unable to set the clamping force, the
specialist dealer will need to check the quick
release.
6.5.4 Retracting the brake linings
Disc brakes require wearing-in time. The braking
force increases over time. You therefore need to be
aware that the braking force may increase during the
wearing-in period. The same happens after brake
pads or discs are replaced.
To Next Page
Loading...