EasyManua.ls Logo

Hercules Rob Family F360 - Basic Cleaning; Cleaning the Frame; Cleaning the Stem; Cleaning the Wheel

Hercules Rob Family F360
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MY21H01 - 32_1.0_30.07.2020
60
Cleaning and servicing
7.2 Basic cleaning
Remove battery and display before thorough
cleaning.
7.2.1 Cleaning the frame
1 Soak the entire frame with dish-washing
detergent if the dirt is thick and ingrained.
2 After leaving it to soak for a short time, remove
the dirt and mud with a sponge, brush and
toothbrushes.
3 Use a watering can or your hand to rinse the
frame.
4 Service the frame after cleaning.
7.2.2 Cleaning the stem
1 Clean stem with a cloth and soapy water.
2 Service the stem after cleaning.
7.2.3 Cleaning the wheel
1 Check the tyres, rims, spokes and spoke
nipples for any damage while cleaning the
wheel.
2 Use a sponge and a brush to clean the hub and
spokes from the inside to the outside.
3 Clean the rim with a sponge.
7.2.4 Cleaning the drive elements
1 Spray the cassette, the chain wheels and the
front derailleur with a degreasing agent.
2 Clean coarse dirt with a brush after soaking for
a short time.
3 Wash down all parts with dish-washing
detergent and a toothbrush.
4 Service the drive elements after cleaning.
Crash caused by brake failure
The braking effect may be unusually poor
temporarily after cleaning, servicing or repairs.
This may cause a crash with injuries.
Never apply care products or oil to the brake
discs or brake linings, or the braking surfaces
on the rims.
After cleaning, servicing or repair, carry out a
few test brake applications.
Notice
Water may enter the inside of the bearings if you
use a steam jet. This dilutes the lubricant inside,
the friction increases and, as a result, the
bearings are permanently damaged in the long
term.
Never clean the pedelec with a pressure
washer.
Greased parts, such as the seat post, the
handlebars or the stem, may no longer be safely
and reliably clamped.
Never apply grease or oil to clamping sections.
Required tools and cleaning agents:
•Cloths
Sponge
•Air pump
•Brush
Toothbrush
Paintbrush
Watering can
•Bucket
•Water
Dish-washing liquid
Degreaser
Lubricant
Brake cleaner or spirit
CAUTION
!
Crash caused by braking hard on rims
A rim can break and block the wheel if you brake
hard. This may cause a crash with serious
injuries.
Check rim wear on a regular basis.
WARNING
!

Table of Contents