HermanMiller Motia Sit-to-Stand Tables User Manual

Once you hear two clicks, release
the buttons.
z Motia Sit-to-Stand Tables
Adjustment Guide
1
z
Motia
™
Sit-to-Stand Tables
Y
Simple Touch Switch Adjustment Guide
How to adjust the height of the table
How to clear a lower or upper height limit How to calibrate the table
Calibrate at installation so legs are in sync or if legs become out of sync
during operation.
Press and hold the up arrow to
raise the table.
Raise or lower the table to one
of the saved height limits.
Adjust the table to the lowest height.
Once you hear one click,
release the buttons.
The table will begin to readjust itself
if necessary. Release the button once
the table has stopped moving and
clicking. Listen carefully; the clicks
are quiet.
Press and hold the down arrow
to lower the table.
Press and hold the up and down
arrows at the same time until you
hear one click (– seconds).
Press the down arrow again and
hold for – seconds.
How to save a lower and upper height limit
Raise or lower the table to
desired height.
Press and hold the up and down
arrows at the same time until you hear
two quiet clicks (– seconds).

HermanMiller Motia Sit-to-Stand Tables Specifications

General

Brand	HermanMiller
Model	Motia Sit-to-Stand Tables
Category	Indoor Furnishing
Language	English

Summary

Simple Touch Switch Adjustment

Adjust Table Height

Press and hold the up arrow to raise or the down arrow to lower the table.

Save Height Limit

Press and hold both arrows until two clicks (10-15s), then release to save.

Clear Height Limit

Press and hold both arrows until one click (10-15s), then release to clear.

Calibrate Table

Adjust to lowest height, press down arrow for 5-10s for self-readjustment.

Programmable Control Adjustment

Adjust Table Height

Press and hold the up arrow to raise or the down arrow to lower the table.

Save Lower/Upper Height Limit

Press and hold both arrows until two clicks (10-15s), then release to save.

Clear Lower/Upper Height Limit

Press and hold both arrows until one click (10-15s), then release to clear.

Save Preferred Height

Adjust table to desired seated or standing height, then press 'S' key.

Programmable Control Functions

Save Preferred Height (Continued)

Press memory key (1-4) to assign number; double click confirms save.

Recall Saved Height

Press and hold assigned memory key until table reaches saved height.

Overwrite Memory Position

Repeat 'Save Preferred Height' steps to overwrite existing setting.

Calibrate Table

Adjust to lowest height, press down arrow for 5-10s for self-readjustment.

Hard Reset Control

Press 1, 2, Up arrow until 'S 5', release. Press Up to 'S 0', press 'S' to confirm.