Need help?Do you have a question about the HermanMiller Mirra and is the answer not in the manual?
General| Chair Type | Office Chair |
|---|---|
| Armrests | Adjustable |
| Weight Capacity | 350 lbs |
| Tilt Limiter | Yes |
| Tilt Tension Control | Yes |
| Seat Depth Adjustment | Yes |
| Material | Steel |
| Seat Height | 16" - 20.5" |
| Warranty | 12-year |
| Back Material | Polymer |
| Adjustability | Height, Seat Depth, Armrests |
| Seat Depth | 15.75" - 18.5" (adjustable) |
| Back Support | Lumbar Support (adjustable) |
| Base | 5-star base, typically aluminum or composite |
| Casters | Carpet casters or hard floor casters available |
Lift the tab up while taking your weight off the chair to raise it.
Lift the tab up while seated to lower the chair.
Turn the knob clockwise to increase tilt tension for more stability.
Turn the knob counterclockwise to decrease tilt tension.
Squeeze the handle under the front of the seat and adjust edge up or down. Release to lock.
Raise the tab to unlock, adjust arm, then lower the tab to lock.
Grasp the front of the armpad and pivot it left or right.
Engage the button on the inside of the armpad and adjust arm in or out.
Recline and flip the lever down to position the chair forward.
Recline and flip the lever up to return to the horizontal position.
Recline and move the lever up to define the limit of recline.
Lean forward and press the lever back to release the tilt limiter.
Move levers up to loosen, then slide lumbar support up or down to desired height.
Adjust levers downward to increase lumbar support.
Raise levers upward to decrease lumbar support.
To Next Page
