HermanMiller Mora System Overhead Storage User Manual

Parts Included
Tools Required
HermanMiller
Mora
™
System Overhead Storage Installation
and Disassembly for Recycling Instructions
How to assemble your Overhead Storage
CH., CH. Wall Mounted Cases)
Power Driver
Level
Overhead Storage Glovebox/Paper Towel
Overhead Storage
CH Wall Cleat
Sloped Top Overhead
Storage
Step 1
Phillips Bit
Stud Finder
Laser Level &
Tripod
Drill Bit
Tape Measure
Pencil
Safety Glass
. Position Wall Cleat onto wall.
. Measure distance (. for ” high , . for ” high cabinets)
from Floor to center of bottom holes in wall cleat.
. Measure ” in from where case is to be located to nd the vertical
position of wall cleat. Mark Location.
Wall Cleat
Cabinet
Floor
Note: Please refer to Mora System planning guide for dierent wall
constructions.
”
. (”)
. (”)
CH. Toggle Bolts
Additional Product Needed - Sold Seperately
CH. Ganging Hardware
Note: Field supplied #-/” Flat Washer.
Step 2
Mark Holes
. Set up self-leveling laser to match mark, on wall.
. Align Wall Cleat to level line and distance from outside cabinets. Using
Cleat as template, mark mounting holes.
HermanMiller for Healthcare Assembly Instructions1
1BJM4F rev D

HermanMiller Mora System Overhead Storage Specifications

General

Brand	HermanMiller
Model	Mora System Overhead Storage
Category	Indoor Furnishing
Language	English

Summary

How to Assemble Overhead Storage

Step 1: Position Wall Cleat

Position Wall Cleat, measure distance from floor, and mark wall location for installation.

Step 2: Set Up Laser and Mark Holes

Set up laser to match mark, align Wall Cleat to level line, and mark mounting holes.

Step 3: Drill and Anchor Cleat

Drill holes, insert wall anchors, and secure cleat to wall, using toggles if aligned with studs.

Step 4: Mount Cabinet to Cleat

Mount cabinet onto wall cleat, mate cabinet cleat, and ensure cases are tight.

Step 5: Join Cabinets Together

Drill holes through mating side panels and attach cabinets using clamping screws.

Step 6: Secure Cabinet to Wall

Drill hole in cabinet back and install screw to attach case to wall cleat for anti-dislodgement.

Hinge Adjustment

Adjust Door Up/Down

Adjust door height by turning cam screw clockwise on right hinge to move up, or on left hinge to move down.

Adjust Door Left/Right

Use lateral adjustment screw to move doors left/right or tilt them using hinge arm.

Door and Latch Adjustments

Adjust Door In/Out

Turn screw clockwise to move door closer to side panels, counter-clockwise to move farther away.

Magnetic Latch Adjustment

Adjust yoke in or out using Phillips screwdriver to engage door bumpers correctly.

Disassembly and Recycling

Materials Identification and Segregation

Identify plastic components by recycling codes; treat non-marked as mixed plastic. Use magnet for ferrous metals.