What to do if steel surfaces in my Heta INSPIRE 40's combustion chamber have oxidised?
If you notice steel surfaces in the combustion chamber of your Heta Stove have oxidised due to high temperature, and there are clear cracks or weaknesses in the stove body, the stove must be replaced.
Why is my Heta INSPIRE 40 Stove whistling?
If the stove is whistling, it's likely due to too much chimney draft. To resolve this, install a damper in the flue pipe of your Heta Stove.
What to do if my Heta INSPIRE 40 burns poorly and the glass soots up?
If your Heta Stove burns poorly after start-up and the glass slowly soots up, several factors could be at play: * **Inadequate Chimney Draft**: Improve the chimney draft. * **Insufficient Air Supply**: Refer to the operating instructions for proper usage. * **Damp Wood**: Ensure firewood is dried for at least one year after splitting. * **Firewood Pieces Too Large**: Use smaller pieces of firewood. * **Insufficient Air Supply to the Room**: Open windows or clean the outdoor air connection, depending on the cause.
How to adjust the combustion air for optimal burning.
Step-by-step guide for starting the fire.
Critical safety warning about potential explosions due to improper fuel or air.
Importance of chimney draft for performance and safety.
Guidelines on suitable and unsuitable types of wood fuel.
Procedure to follow in case of a chimney fire.
A table listing faults, causes, troubleshooting steps, and solutions.
Specifies minimum clearances to walls and combustible materials.
Guidelines for connecting the stove to the chimney system.
Requirements for air supply and ventilation for the stove.
Detailed installation clearances based on EN 13 229 standard.
Steps for physically installing the stove unit.
General| Category | Stove |
|---|---|
| Fuel Type | Wood |
| Efficiency | 80% |
| Flue Outlet | Top or Rear |
| Heating Area | Up to 75 m² |
| Flue Outlet Diameter | 150 mm |
| Material | Steel |
To Next Page
