6
MAINTENANCE
Always shut off power to the crane/machine and the
radio remote control system before any assembly,
maintenance or repair.
RECEIVER COMPONENTS
The receiver accepts commands from the remote
control transmitter and interfaces with the
crane/machine controls to activate crane/machine
functions. Each receiver is built to customer
specifications, but includes common components. A
typical receiver layout is shown below.
RECEIVER INSTALLATION
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.
Initial setup or service work must only be
performed by authorized personnel.
DO NOT touch any circuit components on the
circuit board while the main AC or DC power
is on.
DO NOT run control wires with power wires.
Surge suppressors (RC type) must be used
with all magnetic contactors that are
controlled by the radio remote control system.
P1 P2
P3 P4
P5 P6
P7 P8
P9 P10
P11 P12
P13 P14
P15 P16
1
2
3
4
5
6
7
8
9
10
11
1213
23
22
14151617
1819
20
21
1. Enclosure
2. Antenna Base
3. Power Pack
4. Decoder Module
5. Miniflex Antenna
6. Standard RF Module
7. E-Stop Decoder Module
8. End Stop
9. DIN Rail
10. Wire Duct
11. ACM-1 Module
12. AD5S Module
13. SYM-2 Module
14. RK-2 Module
15. REL-6 Module
16. N/O or N/C Relay Module
17. SNZ E-Stop Module
18. EMVS-1 Inteference Suppressor
Module
19. Line Terminal Block
20. Ground Terminal Block
21. Enclosure Cover
22. Gland Plate
23. Optional Quick-Disconnect Base
To Next Page
Loading...
