To Next Page
D
Daisy WhiteheadOct 30, 2025
What to do if HETRONIC BMS-1 Remote Control system will not initialize?
- SStephanie WallOct 30, 2025
If your HETRONIC Remote Control system won't initialize after the normal start-up procedure, here's what to check: 1. **E-Stop Reset:** If the system was stopped due to an E-Stop condition, you must press the Start button twice. The first press clears the E-Stop, and the second starts the system. 2. **Joystick/Paddle Lever Position:** Make sure all joysticks and paddle levers are in the center position when you press the Start button. 3. **E-Stop Switch:** Verify that the E-Stop switch is not engaged. Pull it out and restart the system by pressing Start twice. 4. **Battery Charge:** Check the battery to ensure it's fully charged. Replace it with a charged battery if needed. 5. **Receiver Power:** Check the diagnostic LEDs on the side of the receiver to confirm it's receiving power. A...
General
