15
If the system does not operate after normal start-up as
described in Operation Section of this manual, follow
the recommended troubleshooting sequence to help
isolate the cause and determine corrective action.
If the system will not respond to the steps below or the
LEDs indicate a failure, contact the Hetronic Service
Department or your authorized dealer.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
System will not initialize
after normal start-up
procedure
E-Stop reset Push the Start button again. If the system is
being initialized from an E-Stop condition,
the Start button must be pressed twice - first
to clear the E-Stop, then to start the system.
Joystick or paddle lever not in
center position
Ensure that all joysticks and paddle levers
are in center position when the Start button
is activated.
E-Stop switch engaged Pull out E-Stop switch. Restart system by
pressing Start twice.
Battery fully discharged Check battery to ensure a full charge.
Replace with fully charged battery if
necessary.
No power to the receiver Check the diagnostic LEDs on the side of
the receiver to be sure power is applied.
Ensure that the system is grounded to the
negative battery terminal. The LEDs also
indicate normal transmitter communication,
interference, and E-Stop conditions.
To Next Page
Loading...
