5
4. Refer to machine’s operator manual for further
instructions.
MAINTENANCE
Always shut off power to the machine and the radio
remote control before any assembly, maintenance or
repair.
MOUNT THE RECEIVER
Install Receiver and Output Wiring
Select a position for the receiver that provides
protection from violent impact from debris or thrown
materials and is easily accessible. The receiver
housing is rated IP65 and can withstand direct water jet
spray and is protected against penetration of dust.
Therefore, weather and elements should not be the
primary concern when installing the receiver.
Four mounting holes are required when installing the
receiver unit. The drill pattern and recommended
hardware are shown in the following illustration.
If the receiver includes an attached antenna, mount the
receiver so that the antenna points straight up. The
area around the antenna should be free of
obstructions, especially metal.
GL-2
GL2_0020
Emergency
Pushbutton
Stop
Nova-L
NVL_0010
NVL_0020
Emergency
Pushbuttons
Stop
INSTALLATION
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.
DRILL PATTERN
Drill 4 holes 9/32" (7mm).
Use 1/4" or 6mm bolts.
4.57"
(116 mm)
9.13"
(232 mm)
BMS_0030
8.29"
(210.5 mm)
9.72"
(246.8 mm)
BMS_0040
Antenna must be
vertical (pointing up).
Area must be
free of
obstructions
To Next Page
Loading...
