9
11. Push the "EMERGENCY STOP" pushbutton on
the transmitter. Be sure that no functions can be
activated with the "EMERGENCY STOP"
pushbutton depressed.
IMPORTANT: If any function of the radio remote
control activates with the "EMERGENCY STOP"
engaged, the radio remote control must not be used
until it is repaired.
12. Pull out the "EMERGENCY STOP" pushbutton.
13. Push the green pushbutton "Start/horn" on the
transmitter.
14. Both the radio remote control and the machine
are now ready for operation.
IMPORTANT: To avoid accidental start-up, always
engage the E-stop pushbutton and switch the
transmitter "OFF" when not in use. When the
transmitter is not attached to the operator, the key
switch should be removed and stored in a secure
place.
SPEED CONTROL
This radio remote control system is equipped with a
dual range speed control. The switch allows selection
between high range (rabbit) and low range (snail). The
low range provides <70% of full speed.
EMERGENCY STOP
For all emergency situations, push the E-Stop
pushbutton in. To restart the system, disengage the
E-Stop pushbutton and press the Start/Horn
pushbutton. Be sure any dangerous conditions are
corrected and follow the Start Up Procedure above.
SAFE MODE
When the transmitter battery voltage drops below
approximately 3.4 volts, the system automatically goes
into Safe Mode. A buzzer will sound to indicate a low
battery. At the end of the 30 seconds, the transmitter
sends the E-Stop signal and all crane/machine motion
commands are stopped.
To restart the system, a fully charged battery must be
inserted into the transmitter. Proceed with startup
instructions. Always place the discharged battery
directly into the charger.
PROPORTIONAL FUNCTIONS
The proportional functions and speed ranges are
pre-set by Hetronic according to the valve types. Your
dealer can refer to the basic adjustments at any time.
Only the crane manufacturer, dealer or authorized
service representative is allowed to adjust individual
functions, direction and speed range.
GL-2
GL2_0020
Start
Pushbutton
Nova-L
NVL_0010
NVL_0020
Start
Pushbuttons
WARNING: TO AVOID SERIOUS INJURY
OR DEATH. Switch the machine "OFF" if
there is a fault or any problems with the safety
check. Contact Hetronic or your dealer
immediately to repair the system. NEVER
operate the machine when the
"EMERGENCY STOP" function does not
operate properly.
Improper operation, maintenance or
adjustment may cause serious injury or
damage to equipment and may void the
warranty.
CAUTION: DO NOT OPEN THE RECEIVER.
All relay and proportional outputs are
accessible on the connection plug.
Unauthorized entry into the receiver could
result in damage to equipment and may void
the warranty.
To Next Page
Loading...
