Hettich ROTINA 380 Robotic User Manual

2015 Andreas Hettich GmbH & Co. KG AB3700DEEN
ROTINA 380 Robotic
ROTINA 380 R Robotic
ROTINA 380 RC Robotic
DE
Bedienungs- und Einbauhinweise................................. 4
EN
Operating and installation instructions ........................ 44
Diese Bedienungs- und Einbauhinweise sind nicht für den Anwender
sondern nur für den Hersteller des automatisierten Systems bestimmt.
Weitere Informationen siehe in Kapitel 1 auf Seite 7.
These operating and installation instructions are not for users but are
only meant for the manufacturer of the automated system.
For more information see chapter 1 on page 47.

Hettich ROTINA 380 Robotic Specifications

General

Max Speed	15, 000 RPM
Max RCF	24, 400 x g
Max Capacity	4 x 100 ml
Temperature Control	Yes
Power Supply	230 V, 50/60 Hz
Type	Centrifuge
Acceleration/Deceleration Profiles	9
Drive	Brushless
Timer	1 sec to 99 min
Control	Microprocessor
Dimensions	40 x 55 x 64 cm

Summary

Standards which apply to this device

Safety Information

General Safety Precautions

Covers essential safety rules, prohibitions, and user responsibilities for safe operation.

Unpacking and Transport Preparation

Unpacking the Centrifuge

Removing the Transport Securing Device

Instructions for removing and storing the transport securing device before operation.

Initial Operation and Interface

Initial Operation Steps

Detailed steps for setting up and powering on the centrifuge for the first time.

Hatch Operation

Opening and Closing the Hatch

Hatch with Light Barriers

Lid Operation

Control and Display Elements

Enter Centrifugation Parameters

Running Time Settings

Speed and RCF Settings

Setting the rotational speed (RPM) and relative centrifugal force (RCF).

Start-up and Run-down Parameters

Programming

Inputting and Calling Programs

Centrifugation

Centrifugation with Preselected Time

Performing a centrifugation run with a specific time duration.

Adjusting Parameters During Operation

Modifying Parameters During Run

Emergency Stop Procedure

Executing an Emergency Stop

Steps to perform an emergency stop in critical situations.

Cycle Counter Management

Cooling Functions

Key-Operated Switch Functions

Operating Modes via Key Switch

Describes the functions of different key positions (0, LOCK 2, TEACH).

Rotor Position Adjustment

Setting Rotor Position 1

Procedure for setting the primary rotor position for loading and unloading.

Understanding RCF

High Density Material Centrifugation

Speed Reduction for High Density

Rotor Recognition Process

Automatic Rotor Detection

How the centrifuge detects and identifies installed rotors.

Emergency Lid Release

Manual Lid Release Procedure

Steps for manually opening the lid in case of power failure.

Maintenance and Servicing

General Cleaning and Care

Instructions for cleaning the centrifuge housing, chamber, and rotors.

Disinfection and Contaminant Removal

Guidelines for disinfecting components and removing hazardous contaminants.

Rotor/Accessory Service Life and Autoclaving

Troubleshooting and Faults

Interpreting Error Messages

Guide to understanding common error messages and their causes.

Remedies for Common Faults

Solutions and troubleshooting steps for various error conditions.

Appendix

Rotors and Accessories Details