What does MAX CYCLES PASSED mean on Hettich rotina 380?
If your Hettich Laboratory Equipment displays 'MAX CYCLES PASSED', it means the maximum permissible number of run cycles entered has been exceeded. Replace the buckets with new buckets for safety reasons and reset the cycle counter to "0" after replacing the buckets.
What to do if Hettich Laboratory Equipment shows IMBALANCE 3*?
If your Hettich Laboratory Equipment shows 'IMBALANCE 3*', it means the rotor is unevenly loaded. To resolve this, open the lid, check the rotor loading, and then repeat the centrifugation run.
What does MAINS INTERRUPT 11* mean on Hettich rotina 380 Laboratory Equipment?
If your Hettich Laboratory Equipment shows 'MAINS INTERRUPT 11*', it indicates a loss of mains power during the centrifugation run, meaning the run was not completed. To address this, open the lid and press the [START] button. If necessary, repeat the centrifugation run.
How to troubleshoot TACHO-ERROR 1, 2, 96 on Hettich rotina 380 Laboratory Equipment?
If your Hettich Laboratory Equipment displays 'TACHO-ERROR 1, 2, 96', it could be due to a defective tacho, motor, or electronics. To attempt a fix, open the lid, set the mains switch to [0], wait at least 10 seconds, turn the rotor vigorously by hand, and then set the mains switch to [I]. The rotor must rotate while switching on.
Why does my Hettich Laboratory Equipment show Enter max cycles =
If your Hettich Laboratory Equipment displays 'Enter max cycles =
What to do if Hettich rotina 380 Laboratory Equipment shows N > MAX 5.0, 5.1?
If your Hettich Laboratory Equipment displays 'N > MAX 5.0, 5.1', it indicates an overspeed error. Perform a MAINS RESET.
How to troubleshoot SENSOR-ERROR 91-93 on Hettich rotina 380 Laboratory Equipment?
If your Hettich Laboratory Equipment displays 'SENSOR-ERROR 91-93', it indicates an error or defect in the imbalance sensor. Perform a MAINS RESET.
What causes ° C * -ERROR 97, 98 on Hettich rotina 380?
If your Hettich Laboratory Equipment displays '° C * -ERROR 97, 98', it indicates an error or defect in the electronics. Perform a MAINS RESET.
How do I resolve SER I/O-ERROR 31, 34, 36 on Hettich rotina 380?
If your Hettich Laboratory Equipment displays 'SER I/O-ERROR 31, 34, 36', it indicates an error or defect in the electronics. Perform a MAINS RESET.
How do I troubleshoot CONTROL-ERROR 25.1-25.4 on Hettich rotina 380 Laboratory Equipment?
If your Hettich Laboratory Equipment displays 'CONTROL-ERROR 25.1-25.4', it indicates an error or defect in the electronics. To resolve this, perform a MAINS RESET.
General| Type | Centrifuge |
|---|---|
| Maximum Speed | 15, 000 rpm |
| Maximum RCF | 24, 400 x g |
| Power Supply | 220-240 V, 50/60 Hz |
| Dimensions (W x D x H) | 554 x 706 x 375 mm (Rotina 380), 554 x 706 x 375 mm (Rotina 380 R) |
To Next Page