Heyl Testomat 808 - Indicators for Testomat 808 Instruments; Scope of Delivery; Performance Specifications

Scope of delivery
8
Scope of delivery
1x Testomat
®
808 2019
1x plastic bag containing 1 screw cap with a hole and an insert for the
screw cap of the indicator bottle (500 ml)
2x fuse
1x operating instructions
Special accessories (available separately): Filter inlet, candle filter as
well as pressure regulator
Required hose connections and supply lines for Testomat
®
808 are
available from Heyl.
Performance specifications
Testomat
®
808 is used for the automatic monitoring of residual total
hardness (water hardness) in water. The limit value to be monitored
is determined by the indicator selection.
• Limit values for residual hardness of 0.02 – 5.0 °dH
determinable by indicator selection
• Analysis start:
- Automatic interval mode
(interval pause can be set from 0 – 60 minutes)
- External control
- Manual start
• Extended operating periods due to 500 ml indicator storage
bottle
• RS232 interface for optional firmware update
Indicators for Testomat
®
808 instruments
Indicators with various limit values are available for the application of
Testomat
®
808 instruments according to operational requirements.
Indicator
type
Monitoring
range
Limit value LEDs
(good/poor display)
Measuring result
(information on water quality)
300 – 350
Residual
hardness
0.02 – 5 °dH
“GOOD” green
Residual hardness < indicator limit
value
“POOR” red
Residual hardness > indicator limit
value
All indicator types are available in two bottle sizes (100 ml and
500 ml). Please refer to the section entitled “Testomat
®
808 2019
spare parts and accessories” on page 42 for a detailed list of the
individual indicator types with the respective article numbers.