10
Mostly no sensor head is connected or the head has been changed during the on-state
of the device. A reset of the handheld (turn off and on) will relieve the failure.
The handheld will be turned on by pressing the button <ON/OFF>.
Depending on the mode the main menu will be displayed or the screen for download to
PC. The modes toggle according to the plugged in USB-cable.
Figure 5 - Main menu
During power up the device searches for a valid sensor head. This procedure can take
a few seconds (depending on the sensor type).
2.3 Download to personal computer
The enclosed USB-cable should be plugged in the socket [U]
If this cable is connected to the PC before you power up the device it will be started in
download mode. In this mode no further actions are necessary. The stored data can be
downloaded to the PC with the software MOISTANALYZE. During this mode the
shutdown function is disabled. The device has to be shut down manually after finishing
the download. It is recommended to run the handheld with the enclosed power supply.
Measurement array
Preferences
Delete all
Info
OK
Single array
To Next Page
Loading...