9
2 Initial operation
2.1 Power supply
The device is designed to be used with the enclosed power supply as well as the
included accumulator for independent operation.
Please turn off the device before you plug in the power supply.
The charge indicator is calibrated for the original accumulator. The use of other types of
accumulator can destroy the device but at least causes wrong information about the
charge state.
The use of non rechargeable batteries is forbidden. These batteries could destroy
the device or cause fire.
The recharging process starts automatically when the power supply is connected. This
procedure takes up to 4 hours (depending on the charge state).
2.2 Power up
The sensor head must be plugged in at the socket [S] (7 Pins).
Before you can change the sensor heads you have to turn off the device.
The sensor head type is detected automatically. If the
communication with the head fails an error message
occurs.
Figure 4 – Failure report
Wrong sensorhead:
Used sensorhead 30XXX
Neded sensorhead 30XXX
OK
Messen
To Next Page
Loading...