To Next PageTo Next Page
Need help?Do you have a question about the HF Elfin-EG10 and is the answer not in the manual?
General| Brand | HF |
|---|---|
| Model | Elfin-EG10 |
| Category | Network Hardware |
| Language | English |
Explains the products' use of IP address for network communication via TCP or UDP.
Details the different operational modes available for the DTU products.
Enables automatic addition of registration package data to the server upon connection establishment.
Allows periodic sending of heartbeat data to maintain active server connections for idle modules.
Supports simultaneous communication across up to three independent sockets.
Defines data framing based on the time interval between consecutive bytes received.
Describes the procedures for upgrading DTU firmware via serial port or network connection.
Introduces the IOTService configuration tool for managing DTU operations and settings.
Enables ModbusRTU to ModbusTCP conversion for seamless slave device connectivity.
Allows the module to obtain and query the current NTP time.
Facilitates virtual COM port functionality through IOTBridge, adapting serial parameters.
Supports data transfer for industrial devices using Hi-flying I.O.T script.
Explains how to switch between transparent and AT command line modes using specific serial commands.
Details how to send AT commands without switching modes using a prefix.
Describes using AT commands for querying and setting parameters via SMS.
Introduces the AT command structure and provides a general list of available commands.
Defines the ASCII-based command line structure, including parameters and operators.
