HF Protoss-PW11 User Manual

HF2211S_EW1X_PW1X Operation Guide
http://www.hi-flying.com/ - 1 -
HF2211S_EW1X_PW1X
Operation Guide
This document applies to the following series of products, please refer
to the user manual for product hardware description.
Elfin-EW10
Elfin-EW10-0
Elfin-EW11
Elfin-EW11-0
HF2211S
Protoss-PW11

HF Protoss-PW11 Specifications

General

Wireless Standards	IEEE 802.11 b/g/n
Operating Frequency	2.4 GHz
Model	Protoss-PW11
Security	WEP, WPA, WPA2
Standard	802.11b/g/n
Ports	UART
Encryption	WEP, WPA, WPA2
Operating Temperature	-20°C ~ 70°C
Storage Temperature	-40°C to 85°C
Humidity	5% to 95% (non-condensing)

Summary

Introduction to HF Products

Elfin-EW1X EVK

HF2211S Hardware Overview

Protoss-PW11 Hardware Overview

Hardware Introduction and Connections

Power Supply Requirements

Interface Connection Details

Initial Setup Procedures

Webpage Configuration

Guides on initial setup using the device's webpage, including Wi-Fi connection and obtaining an IP address.

IOTService Configuration

Explains how to use IOTService for managing, configuring, and communicating with multiple devices remotely.

Test Examples and Scenarios

AP Wireless Networking Setup

Explains device operation in AP mode and how STA devices connect to the product's Wi-Fi access point.

TCP Server Test in AP Mode

Guides on performing a TCP server test when the device operates in AP mode, using test tools.

STA Wireless Networking Configuration

Details configuring the device for STA mode to connect to a router and establishing wireless networking.

TCP Server Test in STA Mode

Outlines steps for conducting a TCP server test when the device is configured in STA mode.

STA TCP Client Test Procedure

STA HTTP Client Test

Firmware Upgrade Process

Covers methods for upgrading device firmware, including local upload and IOTService remote upgrade.

Restore Device to Factory Settings

Provides instructions for restoring the device to factory settings via UART CLI command or the nReload button.