HGST Ultrastar 7K4000 (SAS) Hard Disk Drive Specification
45
16.0 Safety Standards
The following shows the safety standards for different countries.
16.1 UL and C-UL Standard Conformity
This drive is used as a component in Information Technology Equipment (ITE) business equipment systems. This drive is
certified for use in the United States per UL 60950-1, Second Edition, A1:2011-12-19 and in Canada per
CSA C22.2 No. 60950-1-07 Second Edition, 2011-12. The cRUus UL component recognition mark is specifically used on
component parts that are part of a larger product or system and indicates compliance with both Canadian and U.S. require-
ments. The recognition mark appears on the drive label and is maintained for the life of the product.
16.2 European Standards Compliance
The product is additionally certified to the following standard:
International Electrotechnical Commission (IEC) Safety Standard:
IEC 60950-1:2005 Second Edition + A1:2009
16.3 German Safety Mark
This product has received the TUV Bauart Certification mark under EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011
safety standard. The GS mark is not applicable to internal subsystem drives.
16.4 Flammability
The printed wiring boards, flex cables, and connectors used in this drive meet or exceed the UL minimum flammability classi-
fications listed in the table below.
The flammability rating is marked or etched on the board.
16.5 Corporate Standards Compliance
This product has been designed to meet the following Corporate Standards:
- NB 3-0501-201 Product Safety, National Requirements-All Countries.
- CS 3-0501-070 Electrical, Mechanical and Flammability
- NB 3-0501-033 Product Safety National Certification Conformity Requirement
- CS 1-9700-020 Eco-Product Design Requirement
Component Flammability Rating
Rigid Printed Wiring Board Min. V-1
Flex Cable - no components Min. V-2
Flex Cable with components Min. V-1
Interface & motor connectors Min. V-2
To Next Page
Loading...
Need help?
General
