What to do if Hi-Target V100 Bluetooth is not connected?
If the Hi-Target Receiver's Bluetooth is not connecting, satellite searching fails, or the network connection fails, reset the device. To do this, power on the device, then long press the power button (more than 6 seconds). When the LED begins flashing, release the power button to reset the receiver, and then restart it.
How to upgrade firmware on Hi-Target V100?
To upgrade the firmware on the Hi-Target Receiver, connect the receiver to a computer. An “UPDATE” disk will appear. Open the disk and copy the firmware files to it. Then, remove the disk and disconnect the USB cable. Finally, restart the GNSS receiver; it will upgrade the firmware automatically.
Covers important warnings and safety precautions for using the product.
Lists key features such as supported constellations, Bluetooth, and memory.
Highlights important warnings for operation and setup, including temperature and environment.
Explains battery, adapter, charging, and power modes.
Specifies operating conditions like temperature, moisture, and dust.
Details how to switch between static and RTK modes via the device or handheld.
Outlines steps for setting up and measuring for static data collection.
Provides steps for manually upgrading the receiver's firmware.
Details supported constellations, channel number, output formats, and positional accuracy.
General| Waterproof/Dustproof | Yes |
|---|---|
| IP Rating | IP67 |
| Signals Tracked | GPS, GLONASS, Galileo |
| Positioning Accuracy (RMS) | Horizontal: 8mm + 1ppm, Vertical: 15mm + 1ppm |
| Static Accuracy | Horizontal: 2.5 mm + 0.5 ppm; Vertical: 5 mm + 0.5 ppm |
| Positioning | RTK, Static |
| Tilt Survey | Supported |
| Data Update Rate | Up to 20 Hz |
| Communication | Bluetooth, Wi-Fi, USB |
| Storage Temperature | -40°C to +70°C |
To Next Page
