What to do if Hi-Target V100 Bluetooth is not connected?
If the Hi-Target Receiver's Bluetooth is not connecting, satellite searching fails, or the network connection fails, reset the device. To do this, power on the device, then long press the power button (more than 6 seconds). When the LED begins flashing, release the power button to reset the receiver, and then restart it.
How to upgrade firmware on Hi-Target V100?
To upgrade the firmware on the Hi-Target Receiver, connect the receiver to a computer. An “UPDATE” disk will appear. Open the disk and copy the firmware files to it. Then, remove the disk and disconnect the USB cable. Finally, restart the GNSS receiver; it will upgrade the firmware automatically.
General| Waterproof/Dustproof | Yes |
|---|---|
| IP Rating | IP67 |
| Signals Tracked | GPS, GLONASS, Galileo |
| Positioning Accuracy (RMS) | Horizontal: 8mm + 1ppm, Vertical: 15mm + 1ppm |
| Static Accuracy | Horizontal: 2.5 mm + 0.5 ppm; Vertical: 5 mm + 0.5 ppm |
| Positioning | RTK, Static |
| Tilt Survey | Supported |
| Data Update Rate | Up to 20 Hz |
| Communication | Bluetooth, Wi-Fi, USB |
| Storage Temperature | -40°C to +70°C |
To Next Page
