Page 4-16 December 2016
Printer Preferences PLT-01668, Version: 1.2
Head Contact Offset
This setting is a calibration driven value and should not be adjusted. If the
printhead assembly is replaced then this value may need to be adjusted.
This setting is factory set and should not be changed unless directed by a
technician.
Head Queue Offset
This setting is a calibration driven value and should not be adjusted. If the
printhead assembly is replaced then this value may need to be adjusted.
This setting is factory set and should not be changed unless directed by a
technician.
Head Card Thickness
Offset
Adjusts the card handling path to allow for variances in card thickness.
Head Smart Card
Engage Offset
Adjusts the position of the print head to allow smart card encoder contact.
Head Mag Offset Adjusts the printhead for magnetic encoding.
Overlay Heat Adjust Adjusts the temperature setting for overlay film.
10 Mil Card Queue
Offset
Adjusts the input queue for use with thick cards.
Erase Speed Adjusts the speed of the erasure process.
Standard Resin Head
Adjust
Use this adjustment for Black standard resin text and bar codes if they
appear faded, too light or too dark.
Maximum Adjustment Range is +/- 100.
This control can be helpful for fine-tuning the transfer of resin text and bar
codes.
Printhead Smart Cue
Offset
Adjusts the card handling path to allow for variances in card thickness.
Field Description
To Next Page
Loading...
