To o l B ox Page 4-14
L000950, Version: 4.0 February 2016
Setting Description
Cleaning Rate
This adjustment changes the cleaning rate from 3000 to whatever the new
setting is.
Film Print Cooling Level
This controls the speed of the transfer roller cooling fan during the printing
process.
This setting should normally be off, but can be turned on to help with
splotchy color areas on the image.
Note: Too high of a fan speed can cause smudge.
Film Transfer Cooling Level
This controls the default speed of the cooling fan for the transfer process.
Adjustments can be made to both fan speeds and on-times during
transferring.
Note: This setting affects both flash and smudge.
Environmentally Adaptive
Transfer (EAT) Disable
Environmentally Adaptive Transfer automatically adjusts the transfer
temperature based on the ambient air conditions within the printer.
This is an ON (1) or OFF (0) switch. Default is ON.
Note: Settings can increase or decrease the transfer roller temp by as much
as 68° F (20° C) in extreme conditions.
Enable Ribbon Wrinkle
Compensation
This is an ON (1) or OFF (0) switch. Default is ON.
When this is enabled, it will turn on extra pixels on the printhead to help with
ribbon wrinkle during the print process.
Standby Time This option changes the time until the printer enters standby mode.
BEEP Disable
This setting will disable the beep the printer generates after an EE setting
gets updated.
I-Panel Heat Offset
This option adjusts the heat used during the removal of unwanted film.
Note: Use minimal adjustments, or print ribbon and film breaks may occur.
Holo Transfer Offset
This option changes the hologram overlaminate offset placement
parameters.
Standby Temp
This option changes the temperature used when the printer is in standby
mode.
Mag Hi-Co Voltage Offset
This option changes the voltage going to the magnetic head.
Note: This is factory set and should only be changed by a technician.
Mag Lo-Co Voltage Offset
This option changes the voltage going to the magnetic head.
Note: This is factory set and should only be changed by a technician.
Mag Flipper Angle Offset
This option changes the angle of the flipper table. Increasing the flipper
angle will rotate the flipper table clockwise.
Note: This is factory set and should only be changed by a technician.
Fluorescent (F) Panel Heat
Offset
This setting adjusts how dark or light the fluorescent panel is printed.
The range is +/- 20.
Lamination End of Form This option changes head lift at end of card.
Lamination Bottom Takeup This option changes tension of laminate roller 1.
Lamination Top Takeup This option changes tension of laminate roller 2.
To Next Page
Loading...
