8 T560MANK5.DOCX
2.
Specifications: T560 Delay/Pulse Generator
FUNCTION 4-channel di
ital dela
and pulse
enerato
GATE FUNCTION Programmable as level sensitive enable input, edge triggered
burst enable input, or divisor enabled output
GATE INPUT Programmable termination, 50 Ω or 500 Ω to +2.5 V
Logic low -0.3 V min, +0.7 V max
Lo
ic hi
h +2 V min, +5 V max
GATE OUTPUT Logic low +0.1 V typical, +0.4 V max @ 50 mA
Lo
ic hi
h +5 V t
pical, +4 V min
50 m
TRIGGER SOURCES Internal DDS: 0 to 16 MHz, 0.02 Hz resolution
Internal clock: 80 MHz
Remote command or External si
nal
TRIGGER DIVISOR 1 to 2
32
-1, 125 MHz max input
EXTERNAL
TRIGGER INPUT
Programmable termination, 50 Ω or 10 kΩ to ground
Pro
rammable tri
er level
+0.25 to +3.3 volts
and slope
CHANNEL OUTPUTS
, B, C, D
Four pulse outputs, 5 V, 50 Ω source impedance, each
pro
rammable for dela
, width, polarit
DELAY RANGE 0 to 10 seconds, 10 ps resolution
WIDTH RANGE 2 ns to 10 seconds, 10 ps resolution
INSERTION DELAY 21 ns ± 400 ps, external tri
er to an
output
DIFFERENTIAL
NONLINEARITY
< 200 ps
JITTER < 35 ps typical (50 ps max) RMS, external trigger to any output or
between any outputs
dd clock
itter for dela
s > 500 μs
TRIGGER RATE 0 to 16 MHz, limited to 1/
dela
+width+60 ns
max
RISETIME 750 ps max
FALLTIME 750 ps max
CLOCK Internal 10 MHz VCXO, 1 ppm initial accuracy, < 2 ppm/year drift
Added jitter below 10 ns per second of delay
TC below 0.2 PPM/°C
Connector provides clock in/out
Locks to external source
Clock jitter and delay errors are zero relative to external source
Optional hi
he
-performance OCXO
TIMING
CCURACY ± 400 ps ± 7.5 ps/°C ± clock accurac
BURST Programmable to fire N times out of each M triggers
where N and M are 1 to 2
32
-1
OPERATING
TEMPERATURE
0 to 50°C, non-condensing
STORAGE
TEMPERATURE
-20 to 80°C
CALIBRATION
INTERVAL
One year
POWER +12 ± 0.25 volts, 0.3 amps max; 0.4 amps max with Ethernet
Universal AC adapter supplied with evaluation packa
e